![]() Keep the key pressed until the LED (Green) under the TV Power key of STB RC blinks twice to indicate success. On the TV RC, press the key, whose function you wish to copy to the STB RC.On the STB RC, press the key that will store the copied data, the LED under the STB power key will blink once to indicate successful selection of allowed key (see Dedicated keys to be programmed).Emitting diodes of both RCs should be no covered with stickers, cases, etc. Emitting (IR) diode of original RC ( TV RC) must face the STB RC’s IR window. Place STB RC and TV RC on a stable flat surface, directly opposite each other, at a maximum distance of 5 cm.Entry into the RC setup mode is confirmed with the visual LEDs: TV power key LED (Green) and STB power key LED (Red) turn ON and remain ON. On the STB RC, press the ‘Red’ and ‘Blue’ keys of ‘Additional functions’ at the same time and hold them down together for 3 seconds. ![]() The default behavior can only be restored if the RCU’s memory is erased (see Reset STB remote to the factory settings ). ![]() ![]() After copying an IR command from another RC, the key which stored the IR data will stop transmitting the corresponding STB function (if it had any) and start transmitting the copied function. After that, you will be able to turn on/off the TV from the STB RC (direct STB RC to the TV set and press A/V key). For example, if you want to turn on/off the TV from the STB RC, you should assign the On/Off command of the TV RC to one of the programmable STB RC keys (the A/V key, for instance).
0 Comments
Leave a Reply. |